Configuring Pbr With Other Features; Unsupported Features - Lenovo RackSwitch G8264 Application Manual

Configuring PBR with other Features

Unsupported Features

© Copyright Lenovo 2016
Consider the following PBR behavior when configured with the features given
below:
 DSCP: PBR ACLs can be used to remark an IP packet with a new
precedence/DSCP value. PBR ACL remark statements have higher priority than
the DSCP remark commands configured on ports.
 Virtual Router Redundancy Protocol (VRRP): If PBR is enabled on a VRRP IP
interface, the PBR becomes effective on the interface when the switch becomes
the VRRP master on that IP interface.
 Virtual Link Aggregation Group (VLAG): When configuring PBR on VLAG
ports, you must configure the same PBR policy on both the VLAG peers. You
cannot configure the next hop to be on a remote switch or on the VLAG ports.
PBR cannot be configured for:
 Routed ports
 Multicast traffic
 IPv6 packets
 Simple Network Management Protocol (SNMP)
 Stacking
 Virtual Network Interface Card (vNIC)
 Loopback Interface
Chapter 27: Policy-Based Routing
449