Lenovo RackSwitch G8264 Application Manual page 595

1. Configure the PIM‐SM component as shown in the prior examples, or if using
PIM‐DM independently, enable the PIM feature.
2. Configure a PIM component and set the PIM mode:
3. Define an IP interface for use with PIM:
4. Enable PIM on the IP interface and assign the PIM component:
5. (Optional) Configure PIM border router if the IPMC traffic is flowing between PIM
domains:
© Copyright Lenovo 2016
RS G8264(config)# ip pim enable
RS G8264(config)# ip pim component 2
RS G8264(config­ip­pim­comp)# mode dense
RS G8264(config­ip­pim­comp)# exit
RS G8264(config)# interface ip 22
RS G8264(config­ip­if)# ip address 10.10.2.1 255.255.255.255
RS G8264(config­ip­if)# vlan 102
RS G8264(config­ip­if)# enable
RS G8264(config­ip­if)# ip pim enable
RS G8264(config­ip­if)# ip pim component­id 2
RS G8264(config­ip­if)# exit
RS G8264(config)# ip pim pmbr enable
RS G8264(config)# interface ip 22
RS G8264(config­ip­if)# ip pim border­bit
RS G8264(config­ip­if)# exit
Note: For PIM Dense Mode, the DR, RP, and BSR settings do not apply.
Chapter 36: Protocol Independent Multicast
595