Configuring Mld - Lenovo RackSwitch G8264 Application Manual

Configuring MLD

1. Turn on MLD globally.
2. Create an IPv6 interface.
3. Enable MLD on the IPv6 interface.
4. Configure the MLD parameters on the interface: version, robustness, query
response interval, MLD query interval, and last listener query interval.
© Copyright Lenovo 2016
Following are the steps to enable MLD and configure the interface parameters:
RS G8264(config)# ipv6 mld
RS G8264(config­router­mld)# enable
RS G8264(config­router­mld)# exit
RS G8264(config)# interface ip 2
RS G8264(config­ip­if)# enable
RS G8264(config­ip­if)# ipv6 address 2002:1:0:0:0:0:0:3
RS G8264(config­ip­if)# ipv6 prefixlen 64
RS G8264(config­ip­if)# ipv6 mld enable
RS G8264(config­ip­if)# ipv6 mld version <1‐2>
RS G8264(config­ip­if)# ipv6 mld robust <1‐10>
RS G8264(config­ip­if)# ipv6 mld qri <1‐256>
RS G8264(config­ip­if)# ipv6 mld qintrval <1‐608>
RS G8264(config­ip­if)# ipv6 mld llistnr <1‐32>
(MLD version)
(Robustness)
(In seconds)
(In seconds)
(In seconds)
Chapter 33: Multicast Listener Discovery
529