Configuring Bgp On Routed Ports; Configuring Igmp On Routed Ports - Lenovo RackSwitch G8264 Application Manual

Configuring BGP on Routed Ports

Configuring IGMP on Routed Ports

© Copyright Lenovo 2016
The routed port can be used to establish a TCP connection to form peer
relationship with another BGP router. See Chapter
for details on the BGP protocol and its configuration.
The following BGP configurations are not supported on routed ports:
 Update source ‐ configuring a local IP interface
IGMP querier and snooping can be configured on routed ports. For details, see
Chapter 32, "Internet Group Management Protocol."
To configure IGMP snooping on a routed port, enter the following command in the
Global Configuration mode:
RS G8264(config)# ip igmp snoop port <routed port ID>
To configure fastleave on routed ports, enter the following command in the Global
Configuration mode:
RS G8264(config)# ip igmp fastleave port <routed port ID>
The following IGMP querier commands are supported on routed ports:
RS G8264(config)# ip igmp querier port <routed port ID> ?
election­type Set IGMP querier type
enable Turn IGMP Querier on
max­response Set Queriers max response time
query­interval Set general query interval for IGMP Querier only
robustness Set IGMP robustness
source­ip Set source IP to be used for IGMP
startup­count Set startupcount for IGMP
startup­interval Set startup query interval for IGMP
version Sets the operating version of the IGMP snooping
switch
34, "Border Gateway Protocol,"
Chapter 28: Routed Ports
459