Table of Contents
Advertisement
Replacing the NE0152T
Preparing and Returning the NE0152T
Configuring Vital Product Data
1. Log in to the new NE0152T as directed in
2. Use the following CLI commands to enter the Executive configuration mode:
70
NE0152T Installation Guide
If replacing the NE0152T, remove all associated components and options according
to the instructions in this chapter. Remove and retain clips, cords, cables, modules,
caps or blanks, air-duct option (if installed), and any mounting hardware. These
items can then be reinstalled on the replacement unit.
When you remove the NE0152T from the rack, record the product Machine
Type-Model (MTM) number and serial number to use for the replacement switch.
See
"Before Installing the NE0152T" on page 32
labels on the switch or through the switch firmware interface.
To return the chassis to customer service for replacement, see
Help and Technical Assistance"
is necessary to return a component. After you remove the NE0152T unit, securely
pack it for shipping.
Replace power and fan modules. For details, see
Supply Module" on page 57
page
61.
Install the replacement NE0152T hardware as directed in
NE0152T Hardware and
Vital Product Data (VPD) on the replacement switch as shown in the following
section.
After you install the replacement NE0152T hardware (the new unit), you must
configure the new unit to use the VPD of the unit which was removed (the old unit),
in order to avoid losing any licensed electronic entitlement data. The required
information consists of the old unit's MTM and serial number, which was collected
from the old unit according to
To configure the VPD on a new switch, complete the following steps.
the login prompt, the default username is admin and the default password is
admin.
NE0152T> enable
NE0152T# configure [terminal]
NE0152T(config)#
to help you gather all the required information that
"Removing and Replacing a Power
and
"Removing and Replacing a Fan Module" on
Options"). Once the hardware is installed, configure the
"Before Installing the NE0152T" on page
Chapter 5, "Initializing the
to locate the product information
Appendix A, "Getting
Chapter 3, "Installing
NE0152T". At
32.
Advertisement
Table of Contents
