1. Configure a route map.
2. Define an access list statement and assign an ACL to the route map.
3. Enable the access list.
4. Set next hop IP address i.e. IP address of an adjacent router.
5. Set next hop peer IP address.
446
G8264 Application Guide for ENOS 8.4
IP precedence value: A value or keyword used to set the precedence value of the
matching packets.
You can use a combination of set commands. However, you cannot use the set
commands for DSCP and precedence together in the same route map.
Following are the basic steps and commands for configuring route maps.
RS G8264(config)# routemap <route map number>
RS G8264(configroutemap)# accesslist <1‐32> matchaccesscontrol
RS G8264(configroutemap)# accesslist <1‐32> enable
RS G8264(configroutemap)# set ip nexthop <IP address> [<nh2 IP address>]
OR
Set IP precedence value.
RS G8264(configroutemap)# set ip precedence <value or keyword>
OR
Set IP DSCP value.
RS G8264(configroutemap)# set ip dscp <value>
RS G8264(configroutemap)# set ip nexthop <peer IP address>
<IP ACL number>
[<nh3 IP address>] [<nh4 IP address>]
[accesslist {<access list ID>|<access list range>}]
[accesslist {<access list ID>|<access list range>}]
[accesslist {<access list ID>|<access list range>}]