Lenovo RackSwitch G8264 Application Manual page 505

4. Configure LACP dynamic LAGs (portchannels).
Switch B Configuration
1. Configure VLANs and tagging.
2. Configure an IP interface with IPv4 address, and assign a VLAN.
3. Configure STP. Reset the ports to make the edge configuration operational.
4. Configure an LACP dynamic LAG (portchannel).
5. Configure a static LAG (portchannel).
© Copyright Lenovo 2016
RS G8264(config)# interface port 1
RS G8264(config­if)# lacp key 100
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit
RS G8264(config)# interface port 2
RS G8264(config­if)# lacp key 100
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit
RS G8264(config)# interface port 3
RS G8264(config­if)# lacp key 200
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit
RS G8264(config)# interface port 4
RS G8264(config­if)# lacp key 200
RS G8264(config­if)# lacp mode active
RS G8264(config)# vlan 2,3
RS G8264(config­vlan)# interface port 1­4,6
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# switchport trunk allowed vlan 2,3
RS G8264(config­if)# exit
RS G8264(config)# interface port 5
RS G8264(config­if)# switchport access vlan 2
RS G8264(config)# interface ip 1
RS G8264(config­ip­if)# ip address 10.10.10.2 enable
RS G8264(config­ip­if)# vlan 2
RS G8264(config­ip­if)# exit
RS G8264(config)# interface port 5,6
RS G8264(config­if)# spanning­tree portfast
RS G8264(config­if)# shutdown
RS G8264(config­if)# no shutdown
RS G8264(config­if)# exit
RS G8264(config)# interface port 1,2
RS G8264(config­if)# lacp key 300
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit
RS G8264(config)# portchannel 1 port 3,4 enable
Chapter 32: Internet Group Management Protocol
505