Re-Enabling Locked Accounts; Listing Current Users; Logging Into An End User Account - Lenovo RackSwitch G8264 Application Manual

Re-Enabling Locked Accounts

Listing Current Users

Logging into an End User Account

© Copyright Lenovo 2016
After multiple failed login attempts, the switch locks the user account if lockout
has been enabled on the switch.
The administrator can re‐enable a locked account by reloading the switch or by
using the following command:
RS G8264(config)# access user strong­password clear local user lockout
username <user name>
However, the above command cannot be used to re‐enable an account disabled by
the administrator.
To re‐enable all locked accounts, use the following command:
RS G8264(config)# access user strong­password clear local user lockout
all
The following command displays defined user accounts and whether or not each
user is currently logged into the switch.
RS G8264# show access user
Usernames:
user ­ Enabled ­ offline
oper ­ Disabled ­ offline
admin ­ Always Enabled ­ online 1 session
Current User ID table:
1: name jane , ena, cos user , password valid, online 1 session
2: name john , ena, cos user , password valid, online 2 sessions
Once an end user account is configured and enabled, the user can login to the
switch using the username/password combination. The level of switch access is
determined by the COS established for the end user account.
Chapter 4: Securing Administration
103