Lenovo RackSwitch G8264 Application Manual page 622

3. Turn on VRRP and configure two Virtual Interface Routers.
4. Enable tracking on ports. Set the priority of Virtual Router 2 to 101, so that it
5. Configure ports.
6. Turn off Spanning Tree Protocol globally.
622
G8264 Application Guide for ENOS 8.4
RS G8264(config)# router vrrp
RS G8264(config­vrrp)# enable
RS G8264(config­vrrp)# virtual­router 1 virtual­router­id 1
RS G8264(config­vrrp)# virtual­router 1 interface 1
RS G8264(config­vrrp)# virtual­router 1 address 192.168.1.200
RS G8264(config­vrrp)# virtual­router 1 enable
RS G8264(config­vrrp)# virtual­router 2 virtual­router­id 2
RS G8264(config­vrrp)# virtual­router 2 interface 2
RS G8264(config­vrrp)# virtual­router 2 address 192.168.2.200
RS G8264(config­vrrp)# virtual­router 2 enable
becomes the Master.
RS G8264(config­vrrp)# virtual­router 1 track ports
RS G8264(config­vrrp)# virtual­router 2 track ports
RS G8264(config­vrrp)# virtual­router 2 priority 101
RS G8264(config­vrrp)# exit
RS G8264(config)# vlan 10
RS G8264(config­vlan)# exit
RS G8264(config)# interface port 1
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# switchport trunk allowed vlan 10
RS G8264(config­if)# exit
RS G8264(config)# vlan 20
RS G8264(config­vlan)# exit
RS G8264(config)# interface port 2
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# switchport trunk allowed vlan 20
RS G8264(config­if)# exit
RS G8264(config)# no spanning­tree stp 1