Configuring Multiple STGs
1. Set the Spanning Tree mode on each switch to PVRST.
2. Configure the following on Switch A:
200
G8264 Application Guide for ENOS 8.4
This configuration shows how to configure the three instances of STGs on the
switches A, B, C, and
D illustrated in Figure 14 on page
Because VASA is enabled by default, each new VLAN is automatically assigned its
own STG.
RS G8264(config)# spanningtree mode pvrst
Note: PVRST is the default mode on the G8264. This step is not required unless the
STP mode has been previously changed, and is shown here merely as an example
of manual configuration.
a. Enable VLAN 2 and VLAN 3.
RS G8264(config)# vlan 2
RS G8264(configvlan)# exit
RS G8264(config)# vlan 3
RS G8264(configvlan)# exit
If VASA is disabled, enter the following commands:
RS G8264(config)# spanningtree stp 2 vlan 2
RS G8264(config)# spanningtree stp 3 vlan 3
b. Add port 17 to VLAN 2, port 18 to VLAN 3.
RS G8264(config)# interface port 17
RS G8264(configif)# switchport mode trunk
RS G8264(configif)# switchport trunk allowed vlan 2
RS G8264(configif)# exit
RS G8264(config)# interface port 18
RS G8264(configif)# switchport mode trunk
RS G8264(configif)# switchport trunk allowed vlan 3
RS G8264(configif)# exit
VLAN 2 and VLAN 3 are removed from STG 1.
Note: In PVRST mode, each instance of STG is enabled by default.
199.