Setup Part 3: Vlans - Lenovo RackSwitch G8264 Application Manual

Setup Part 3: VLANs

1. Select the VLAN to configure, or skip VLAN configuration at the prompt:
2. Enter the new VLAN name at the prompt:
3. Enter the VLAN port numbers:
4. Configure Spanning Tree Group membership for the VLAN:
5. The system prompts you to configure the next VLAN:
74
G8264 Application Guide for ENOS 8.4
If you chose to skip VLANs configuration back in Part 2, skip to "Setup Part 4: IP
Configuration" on page
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
If you wish to change settings for individual VLANs, enter the number of the
VLAN you wish to configure. To skip VLAN configuration, press <Enter> without
typing a VLAN number and go to "Setup Part 4: IP Configuration" on page
Current VLAN name: VLAN 2
Enter new VLAN name:
Entering a new VLAN name is optional. To use the pending new VLAN name,
press <Enter>.
Define Ports in VLAN:
Current VLAN 2: empty
Enter ports one per line, NULL at end:
Enter each port, by port number or port alias, and confirm placement of the port
into this VLAN. When you are finished adding ports to this VLAN, press <Enter>
without specifying any port.
Spanning Tree Group membership:
Enter new Spanning Tree Group index [1­255]:
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
Repeat the steps in this section until all VLANs have been configured. When all
VLANs have been configured, press <Enter> without specifying any VLAN.
75.
75.