3. Configure the following on Switch B:
4. Configure the following on application switch C:
5. Switch D does not require any special configuration for multiple Spanning Trees.
Switch D uses default STG 1 only.
© Copyright Lenovo 2016
a. Add port 8 to VLAN 2. Ports 1 and 2 are by default in VLAN 1 assigned to STG
1.
RS G8264(config)# vlan 2
RS G8264(configvlan)# exit
RS G8264(config)# interface port 8
RS G8264(configif)# switchport mode trunk
RS G8264(configif)# switchport trunk allowed vlan 2
RS G8264(configif)# exit
If VASA is disabled, enter the following command:
RS G8264(config)# spanningtree stp 2 vlan 2
b. VLAN 2 is automatically removed from STG 1. By default VLAN 1 remains in
STG 1.
a. Add port 8 to VLAN 3. Ports 1 and 2 are by default in VLAN 1 assigned to STG
1.
RS G8264(config)# vlan 3
RS G8264(configvlan)# exit
RS G8264(config)# interface port 8
RS G8264(configif)# switchport mode trunk
RS G8264(configif)# switchport trunk allowed vlan 3
RS G8264(configif)# exit
If VASA is disabled, enter the following command:
RS G8264(config)# spanningtree stp 3 vlan 3
b. VLAN 3 is automatically removed from STG 1. By default VLAN 1 remains in
STG 1.
Chapter 11: Spanning Tree Protocols
201