Starting A Rolling Upgrade - Lenovo RackSwitch G8264 Application Manual

Starting a Rolling Upgrade

1. Load the boot image with a non‐staggered copy:
2. Load the firmware image with a staggered copy:
316
G8264 Application Guide for ENOS 8.4
To start a rolling upgrade, use the command:
RS G8264(config)# copy {tftp|ftp|sftp} {image1|image2} {address <IP
address>} {filename <image filename>} staggered­upgrade [delay <minutes>]
where:
tftp, ftp, sftp

image1, image2

address

delay

To upgrade both the boot and the firmware images:
RS G8264(config)# copy {tftp|ftp|sftp} boot­image {address <IP address>}
{filename <image filename>}
RS G8264(config)# copy {tftp|ftp|sftp} {image1|image2} {address <IP
address>} {filename <image filename>} staggered­upgrade [delay <minutes>]
is the protocol for copying
is the image to which the firmware is being copied
is the IP address from which the firmware is being
copied
is the delay between each reload, in minutes