Operational Commands; Fip Snooping Configuration - Lenovo RackSwitch G8264 Application Manual

Operational Commands

FIP Snooping Configuration

1. Enable VLAN tagging on the FCoE ports:
© Copyright Lenovo 2016
For example:
RS G8264# show fcoe fips port 21 information
FIP Snooping on port 21:
This port has been configured to automatically detect FCF.
It has currently detected to have 0 FCF connecting to it.
FIPS ACLs configured on this port:
SMAC 00:05:73:ce:96:67, action deny.
DMAC 00:05:73:ce:96:67, ethertype 0x8914, action permit.
SMAC 0e:fc:00:44:04:04, DMAC 00:05:73:ce:96:67, ethertype 0x8906, vlan
1002, action permit.
DMAC 01:10:18:01:00:01, Ethertype 0x8914, action permit.
DMAC 01:10:18:01:00:02, Ethertype 0x8914, action permit.
Ethertype 0x8914, action deny.
Ethertype 0x8906, action deny.
SMAC 0e:fc:00:00:00:00, SMAC mask ff:ff:ff:00:00:00, action deny.
For each ACL, the required traffic criteria are listed, along with the action taken
(permit or deny) for matching traffic. ACLs are listed in order of precedence and
evaluated in the order shown.
The administrator can also view other FCoE information:
RS G8264# show fcoe fips fcf
RS G8264# show fcoe fips fcoe
The administrator may use the operational commands to delete FIP‐related entries
from the switch.
To delete a specific FCF entry and all associated ACLs from the switch, use the
following command:
RS G8264# no fcoe fips fcf <FCF MAC address> [<VLAN number>]
In this example, as shown in Figure 32 on page
port 2 for the FCF device and port 3 for an ENode. You can configure FIP snooping
on these ports using the following commands:
RS G8264(config)# interface port 2,3
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# exit
Note: If you are using Emulex CNA BE 2 ‐ FCoE mode, you must enable PVID
tagging on the Enode ports.
(Show all detected FCFs)
(Show all FCoE connections)
366, FCoE devices are connected to
(
Select FCoE ports)
(
Enable VLAN tagging)
(Exit port configuration mode)
Chapter 21: FCoE and CEE
375