Configuring Lacp - Lenovo ThinkSystem NE2552E Application Manual

Configuring LACP

1. Configure port parameters. All ports that participate in the LACP LAG must have
2. Select the port range and define the admin key. Only ports with the same admin
3. Set the LACP mode.
4. Optionally allow member ports to individually participate in normal data traffic if
5. Set the link aggregation as static, by associating it with LAG ID 65:
172
NE2552E Application Guide for ENOS 8.4
Use the following procedure to configure LACP for ports INTA1 and INTA2 to
participate in a single link aggregation.
the same settings, including VLAN membership.
key can form a LACP LAG.
NE2552E(config)# interface port inta1-inta2
NE2552E(config-if)# lacp key 100
NE2552E(config-if)# lacp mode active
NE2552E(config-if)# exit
no LACPDUs are received.
NE2552E(config-if)# no lacp suspend-individual
NE2552E(config-if)# exit
NE2552E(config-if)# portchannel 65 lacp key 100