Configuring Lacp - Lenovo RackSwitch G8264CS Application Manual

Configuring LACP

1. Configure port parameters. All ports that participate in the LACP LAG must have
the same settings, including VLAN membership.
2. Select the port range and define the admin key. Only ports with the same admin
key can form an LACP LAG.
3. Set the LACP mode.
4. Optionally allow member ports to individually participate in normal data traffic if
no LACPDUs are received.
5. Set the link aggregation as static, by associating it with LAG ID 65:
© Copyright Lenovo 2017
Use the following procedure to configure LACP for ports 7, 8, 9 and 10 to
participate in link aggregation.
RS 8264CS(config)# interface port 7-10
RS 8264CS(config-if)# lacp key 100
RS 8264CS(config-if)# lacp mode active
RS 8264CS(config-if)# no lacp suspend-individual
RS 8264CS(config-if)# exit
RS 8264CS(config)# portchannel 65 lacp key 100
Chapter 9: Ports and Link Aggregation
161