Accessing The Member Switch Cli - Lenovo RackSwitch G8264 Application Manual

Accessing the Member Switch CLI

310
G8264 Application Guide for ENOS 8.4
same software or configuration bank as that on the Master. For example, if the new
image is loaded into image 1 on the Master switch, the Master will push the same
firmware to image 1 on each Member switch.
For easier administration, you can use the Master switch to access the CLI of any
Member switch. Use this feature to display specific Member switch information
such as log messages, system information, and statistics.
Member CLI access is available regardless of whether the Member switch is
operating in the attached state (prior to joining the stack), or in the active state
(having received a configured switch number). Member CLI access is available
even without an assigned IP address or a physical connection to the serial console
on the Member.
To use this feature, log in to the Master switch (via its local serial console or
through a remote Telnet or SSH connection) and issue the following command:
RS G8264# connect <asnum>
where asnum is the attached switch number of the target Member switch.
For example, to access the Member switch identified by attached switch number 3,
enter the following command:
RS G8264# connect 3
Connecting via DATA port.
Connected to 127.117.210.5.
Escape character is '^]'.
Lenovo Networking Operating System RackSwitch G8264, Stack.
Enter login username:
Log in to the Member switch as usual. If the Member switch is in the active state
(after successfully joining the stack), the prompt will include the Member's
configured switch number (csnum), which may be different from the assigned
switch number (asnum):
RS G8264­3>
To return to the Master switch prompt, log out of the Member switch.