Switch Images And Configuration Files - Lenovo RackSwitch G8264 Application Manual

Switch Images and Configuration Files

© Copyright Lenovo 2016
This section describes how to use MIB calls to work with switch images and
configuration files. You can use a standard SNMP tool to perform the actions, using
the MIBs listed in the table below.
The table lists the MIBS used to perform operations associated with the Switch
Image and Configuration files.
Table 47.
MIBs for Switch Image and Configuration Files
MIB Name
agTransferServer
agTransferImage
agTransferImageFileName
agTransferCfgFileName
agTransferDumpFileName
agTransferAction
agTransferLastActionStatus
agTransferPort
agTransferUserName
agTransferPassword
agTransferTSDumpFileName
The following SNMP actions can be performed using the MIBs listed in the table:
 Load a new Switch image (boot or running) from an FTP, SFTP, or TFTP server
 Load a previously saved switch configuration from an FTP, SFTP, or TFTP server
 Save the switch configuration to an FTP, SFTP, or TFTP server
 Save a switch dump to an FTP, SFTP, or TFTP server
MIB OID
1.3.6.1.4.1.26534.2.7.6.1.1.7.1
1.3.6.1.4.1.26534.2.7.6.1.1.7.2
1.3.6.1.4.1.26534.2.7.6.1.1.7.3
1.3.6.1.4.1.26534.2.7.6.1.1.7.4
1.3.6.1.4.1.26534.2.7.6.1.1.7.5
1.3.6.1.4.1.26534.2.7.6.1.1.7.6
1.3.6.1.4.1.26534.2.7.6.1.1.7.7
1.3.6.1.4.1.26534.2.7.6.1.1.7.8
1.3.6.1.4.1.26534.2.7.6.1.1.7.9
1.3.6.1.4.1.26534.2.7.6.1.1.7.10
1.3.6.1.4.1.26534.2.7.6.1.1.7.11
Chapter 41: Simple Network Management Protocol
655