Configuration - Lenovo RackSwitch G8264 Application Manual

Configuration

Switch A Configuration
1. Configure a VLAN.
2. Configure an IP interface with IPv4 address, and assign a VLAN..
3. Assign a bridge priority lower than the default bridge priority to enable the switch
4. Configure LACP dynamic LAGs (portchannels).
514
G8264 Application Guide for ENOS 8.4
 Disabled IGMP flooding.
 Disabled IGMP Snooping.
This section provides the configuration details of the switches in Figure
RS G8264(config)# interface port 1­5
RS G8264(config­if)# switchport access vlan 2
RS G8264(config)# interface ip 2
RS G8264(config­ip­if)# ip address 2.2.2.10 enable
RS G8264(config­ip­if)# vlan 2
RS G8264(config­ip­if)# exit
to become the STP root in STG 2 and 3.
RS G8264(config)# spanning­tree stp 2 bridge priority 4096
RS G8264(config)# interface port 1,2
RS G8264(config­if)# lacp key 100
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit
RS G8264(config)# interface port 3,4
RS G8264(config­if)# lacp key 200
RS G8264(config­if)# lacp mode active
42.