Prerequisites; Configuration - Lenovo RackSwitch G8264 Application Manual

Prerequisites

Configuration

Switch A Configuration
1. Configure VLANs and tagging.
2. Configure an IP interface with IPv4 address, and assign a VLAN.
3. Assign a bridge priority lower than the default bridge priority to enable the switch
504
G8264 Application Guide for ENOS 8.4
 The hosts receive multicast traffic as follows:
Host 1 receives multicast traffic for groups (*, 225.10.0.11), (22.10.0.13,

225.10.0.13)
Host 2 receives multicast traffic for groups (*, 225.10.0.11), (*, 230.0.2.1),

(22.10.0.13, 225.10.0.13), (22.10.0.3, 230.0.2.3)
Host 3 receives multicast traffic for groups (*, 230.0.2.1), (22.10.0.3, 230.0.2.3)

 The Mrouter receives all the multicast traffic.
Before you configure IGMP Snooping, ensure you have performed the following
actions:
 Configured VLANs.
 Enabled IGMP.
 Added VLANs to IGMP Snooping.
 Configured a switch or Mrouter as the Querier.
 Identified the IGMP version(s) you want to enable.
 Disabled IGMP flooding.
This section provides the configuration details of the switches shown in Figure
RS G8264(config)# interface port 1­5
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# switchport trunk allowed vlan 2,3
RS G8264(config­if)# exit
RS G8264(config)# interface ip 1
RS G8264(config­ip­if)# ip address 10.10.10.1 enable
RS G8264(config­ip­if)# vlan 2
RS G8264(config­ip­if)# exit
to become the STP root in STG 2 and 3.
RS G8264(config)# spanning­tree stp 2 bridge priority 4096
RS G8264(config)# spanning­tree stp 3 bridge priority 4096
41.