Configure A Discrete Input - Emerson Micro Motion 5700 Configuration And Use Manual

Configuration and Use Manual
MMI-20029769
Fault indication with a Discrete Output
To indicate faults via a Discrete Output, set Discrete Output Source to Fault. Then, if a fault occurs, the
Discrete Output is always ON and the setting of Discrete Output Fault Action is ignored.

8.7 Configure a Discrete Input

Use a Discrete Input to initiate one or more transmitter actions from a remote input device.
Related information
Configure a Discrete Input or discrete event
8.7.1 Configure Discrete Input Action
Display Menu > Configuration > Inputs/Outputs > Channel C > I/O Settings > Assign Actions
ProLink III Device Tools > Configuration > I/O > Inputs > Action Assignment
Device Tools > Configuration > I/O > Inputs > Action Assignment
Web browser Configuration > Inputs/Outputs > Channel C > Discrete Input > Action Assignment
Discrete Input Action controls the action or actions that the transmitter will perform when the Discrete Input
transitions from OFF to ON.
CAUTION
Before assigning actions to a Discrete Input, check the status of the remote input device. If it is ON, all
assigned actions will be performed when the new configuration is implemented. If this is not acceptable,
change the status of the remote input device or wait until an appropriate time to assign actions.
Procedure
Set Discrete Input Action as desired.
• Default: None
Options for Discrete Input Action
Action
Standard
Start sensor zero
Totalizers
Start/stop all totalizers and
inventories
Reset totalizer X
Reset all totalizers and
inventories
Configuration and Use Manual
Display
Start Zero Calibration
Start/stop all totalizers
Reset Total X
Reset All Totals
Integrate the meter with the control system
Label
ProLink III
Start Sensor Zero
Start or Stop All Totalizers
Totalizer X
Reset All Totals
March 2019
Web browser
Start Sensor Zero
Start/Stop All Totals
Reset Total X
Reset All Totals
127