Emerson Micro Motion 5700 Configuration And Use Manual page 135

Configuration and Use Manual
MMI-20029769
Web browser
8. Perform a test print to verify the settings are correct.
Display
ProLink III
Web browser
If needed, see Function Check Failed in the Status alerts, causes, and recommendations section .
10.2.2 Set up the printer using the printer default IP address
Use this procedure to set up printing with a Model 5700 Ethernet transmitter and an Epson TM-T88VI printer
using the printer's default IP address.
Procedure
1. Connect one end of an Ethernet cable and power supply to the printer.
2. Connect the other end of the Ethernet cable to the PC.
3. Power on the printer.
It can take 1-2 minutes for the printer to finish configuring network settings. When complete, the
following ticket prints.
*********************************
IP Address : 192.168.192.168
SubnetMask : 255.255.255.0
Gateway : 0.0.0.0
DHCP : No server - > Static
*********************************
4. Turn off DHCP if it is enabled.
From the display
a. Go to Menu > Configuration > Ethernet Settings
> Network Settings > Auto obtain IP()DHCP.
b. Select Disabled and Save.
c. Back out to the Ethernet Settings page to apply
the DHCP off setting.
5. Configure the IP address.
a) Navigate to one of the following screens:
From the display
Go to Menu > Configuration > Ethernet Settings >
Network Settings > IP address.
Configuration and Use Manual
Configure, setup, and use a printer for tickets
Configuration > Printer and Tickets
Menu > Operations > Printer > Print Ticket > Print Test Page
Device Tools > Configuration > Printer and Tickets
Configuration > Printer and Tickets
From ProLink III
a. Go to Device Tools > Configuration > Network
Settings.
b. Uncheck Obtain an IP address automatically
(DHCP).
c. Select Apply.
From ProLink III
Go to Device Tools > Configuration > Network
Settings.
March 2019
135