Log In With A Web Browser Using A Secure Connection - Emerson Micro Motion 5700 Configuration And Use Manual

Using a Web browser to configure the transmitter
March 2019
Table C-1: Transmitter and PC network settings
Connection type
Direct connection: Ethernet cable
connected directly between Channel A
or Channel B and the PC Ethernet
adapter.
Local network connection: The
transmitter and PC are connected to a
common network with a DHCP.
Note
If IP Address cannot be changed (and IP Address set from Local Display Switches appears selected on
Prolink III or on a web browser page), the rotary switches on the back side of the display circuit board have
been used to manually set the 4th octet of the IP address and the IP address cannot be changed using the
software or display. For example, if the rotary switches are set to 005, then the IP address for the transmitter
is 192.168.0.005. To remove this restriction, set the rotary switches to 000.
Note
If your PC has more than one wired network adapter, be sure to select the adapter that is connected to the
transmitter.
C.3 Log in with a web browser using a secure connection
You must enable the webserver SSL/TLS in order to log in with a web browser. The SSL Certificate shipped
with the transmitter is for IP address 192.168.0.1. After configuring the IP address, you must download a new
SSL Certificate, and then import the new certificate into the web browser.
The Model 5700 Ethernet transmitter is shipped with SSL disabled by default. This procedure is applicable
only if the SSL is enabled. If the SSL/TLS is enabled, and you changed the default IP address, order of operation
is as follows:
1. Enable SSL/TLS.
2. Change the IP address.
258
Transmitter network settings
• Auto Obtain IP (DHCP): Disabled
• IP address: any IP address in the
same subnet as the PC network
adapter. Recommended
192.168.0.1
Subnet mask: 255.255.255.0
•
Default Gateway: 0.0.0.0 (this
•
indicates that no gateway will be
used)
All settings to be assigned by network
administrator. Typical network
settings shown.
• Auto Obtain IP (DHCP): Enabled
• IP address: automatically assigned
by DHCP
• Subnet mask: 255.255.255.0
• Default Gateway: 0.0.0.0 (this
indicates that no gateway will be
used)
Configuration and Use Manual
PC network adapter IPv4 settings
• Auto Obtain IP (DHCP): Disabled
• IP address: any IP address in the
same subnet as the PC network
adapter. Recommended
192.168.0.2
Subnet mask: 255.255.255.0
•
Default Gateway: none (leave
•
blank)
All settings to be assigned by network
administrator.
Micro Motion Model 5700 with Ethernet Transmitters
MMI-20029769