Emerson Micro Motion 5700 Configuration And Use Manual page 137

Configuration and Use Manual
MMI-20029769
Software or license
version
ProLink III 4.2 or later
Transmitter software 2.0
or later
Procedure
1. Ensure that the transmitter is in unsecure mode in order to make the configuration changes for this
procedure.
2. Configure the printer parameters.
Display
ProLink III
Related information
Upgrade the transmitter firmware
Printer, ticket, and heading parameters
10.4.1 Printer, ticket, and heading parameters
Table 10-1: Printer configurable parameters
Ticket parameters
Printer Type
Printer IP Address
Table 10-2: Ticket configurable parameters
Ticket parameters
Number of Batch Tickets
Auto Print
Batch Count Start Number
Configuration and Use Manual
Where to look
From ProLink III, Help
From the display: Menu > About > Versions > Transmitter Software
•
• From ProLink III, Device Tools > About > Versions > Transmitter Software
Menu > Configuration > Printer
Device Tools > Configuration > Printer and Tickets
Description
• Epson TM-T88VI – Uses 3.15 in (80.0 mm) thermal paper rolls
• Generic – does not support the Paper Out function
Default values:
Left Most Octet: 192
Left Middle Octet: 168
Right Middle Octet: 192
Right Most Octet: 168
Modify the default values based on the network using the printer.
Description
The number of batch tickets to be printed by the Auto Print function (if Auto
Print is enabled) or by a manual print request.
The default is 1.
• Select Yes to have batch tickets printed automatically at the end of each
batch. Tickets will be printed only if flow is stopped.
• Select No to not have batch tickets printed automatically at the end of each
batch.
Starting ticket number for the batch count.
Configure, setup, and use a printer for tickets
March 2019
137