Chapter 17 Troubleshooting; Status Led And Device Status; Network Status Led; Api Referral Problems - Emerson Micro Motion 5700 Configuration And Use Manual

Configuration and Use Manual
MMI-20029769
17 Troubleshooting

17.1 Status LED and device status

The status LED (MOD STATUS) on the transmitter display provides a quick indication of device status by
changing color and flashing. If the transmitter was ordered without a display, the LEDs on the outputs board
inside the transmitter provide the same information.
Table 17-1: Status LED and device status
Status LED condition
Solid green
Solid yellow
Solid red
Flashing yellow (1 Hz)

17.2 Network status LED

The network status LED (NET STATUS) on the transmitter display provides a quick indication of the Ethernet
network connection status by changing color and flashing.
Table 17-2: Network status LED and Ethernet network connection status
Network status LED condition
Flashing green
Solid green
Flashing red
Solid red

17.3 API referral problems

17.3.1 Extrapolation alert is active
Cause
Line pressure, line temperature, or line density is outside the range of the configured API table.
Recommended actions
1. Check your process conditions against the values reported by the device.
2. Verify the configuration of the API referral application and related parameters.
Configuration and Use Manual
Device status
No alerts are active.
One or more alerts are active with Alert Severity = Out of Specification,
Maintenance Required, or Function Check.
One or more alerts are active with Alert Severity = Failure.
The Function Check in Progress alert is active.
Ethernet network status
No connections made with primary protocol host.
Connection made with primary protocol host.
Connection from primary protocol host has timed out.
Address Conflict Detection (ACD) algorithm has detected a duplicate IP
address.
Troubleshooting
March 2019
195