Emerson Micro Motion 5700 Configuration And Use Manual page 19

Configuration and Use Manual
MMI-20029769
• If the switch is in the right position, the transmitter is locked.
• If the switch is in the left position, the transmitter is unlocked.
Note
The top switch is reserved for future use.
Procedure
1. If you are in a hazardous area, power down the transmitter.
DANGER
Never remove the transmitter housing cover in a hazardous area when the transmitter is powered
up. Failure to follow these instructions may result in an explosion.
2. Remove the transmitter housing cover.
Figure 3-2: Removing the transmitter housing cover
3. Using a fine-pointed tool, move the switch to the desired position.
4. Replace the transmitter housing cover.
5. If necessary, power up the transmitter.
3.1.4 Enable or disable the service port
Display Menu > Configuration > Security > Service Port
ProLink III Not available
Web browser Not available
Configuration and Use Manual
Introduction to configuration and commissioning
March 2019
19