Emerson Micro Motion 5700 Configuration And Use Manual page 248

Using the transmitter display
March 2019
Table A-1: Status LED and device status
Status LED condition
Solid yellow
Solid red
Flashing yellow (1 Hz)
Table A-2: Network status LED and Ethernet network connection status
Network status LED condition
Flashing green
Solid green
Flashing red
Solid red
LCD panel
In normal operation, the LCD panel shows the current value of the display variables, and their measurement
units.
Figure A-3: Model 5700 transmitter LCD panel
The LCD panel also provides access to the display menus and alert information. From the display menus, you
can:
• View the current configuration and make configuration changes.
• Perform procedures such as loop testing and zero verification.
• Run batches.
The alert information allows you to see which alerts are active, acknowledge the alerts individually or as a
group, and to see more detailed information for individual alerts.
248
(continued)
Device status
One or more alerts are active with Alert Severity = Out of Specification,
Maintenance Required, or Function Check.
One or more alerts are active with Alert Severity = Failure.
The Function Check in Progress alert is active.
Ethernet network status
No connections made with primary protocol host.
Connection made with primary protocol host.
Connection from primary protocol host has timed out.
Address Conflict Detection (ACD) algorithm has detected a duplicate IP
address.
Configuration and Use Manual
Micro Motion Model 5700 with Ethernet Transmitters
MMI-20029769