Emerson Micro Motion 5700 Configuration And Use Manual page 134

Configure, setup, and use a printer for tickets
March 2019
• IP address: 192.168.192.x, where x is something other than 0, 1, or 168
• Subnet mask: 255.255.255.0
e) Select OK.
5. Change the printer firmware options.
a) Open your web browser and type http://192.168.192.168 (default printer IP).
The browser displays, Your connection is not private . Ignore the warning and proceed
to the website.
b) Select ADVANCED.
c) Select Proceed to 192.168.192.168.
d) At the login screen, enter:
Default username: epson
Default password: epson
The EpsonNet Config utility screen displays.
e) Select TCP/IP under the configuration settings (not the basic settings), listed on the left side of
the screen.
f) Change the IP Address (i.e., 192.168.1.55), Subnet Mask, and Default Gateway based on your
network. Select an IP address that is unique to the local network.
The printer must be on the same subnet as the Model 5700.
g) Required: Set Acquiring the IP Address to Manual.
h) Select Send to save your settings.
i) Select Reset, or power cycle the printer when prompted to apply the changes.
6. Change the PC network settings back to the original settings.
Use the windows you used in
7. Configure the Model 5700 Ethernet transmitter for the printer.
a) Remove the Ethernet cable from the PC and connect it to the Model 5700 Ethernet transmitter.
b) If you have not already done so, configure the transmitter IP address, subnet mask, and default
gateway.
Display
ProLink III
See Connect ProLink III to the
c) Enter the printer IP address you configured in the previous step into the Model 5700 Ethernet
transmitter.
Display
ProLink III
134
Step 4.
Menu > Configuration > Ethernet Settings > Network Settings
Device Tools > Configuration > Network Settings
transmitter.
Menu > Configuration > Printer > Printer IP address
Device Tools > Configuration > Printer and Tickets
Configuration and Use Manual
Micro Motion Model 5700 with Ethernet Transmitters
MMI-20029769