Emerson Micro Motion 5700 Configuration And Use Manual page 275

Configuration and Use Manual
MMI-20029769
• There were no changes to the EtherNet/IP EDS file or the PROFINET GSDXML file.
• Corrected alert notifications so if an alert happens and is acknowledged, the alert will re-assert if a new
condition for that alert becomes active.
• Enhanced Totalizer History so it reports 24 hours of data.
• Enhanced support for channel assignment so a setting of 'None' is preserved across a power cycle.
• Corrected milliamp output upper range and lower range values so they can no longer be equal.
• Enhanced secure mode so writing static external pressure and temperature no longer occurs.
• Support added so users can reset individual totalizers from the local display.
• Corrected the water density values in the standard Plato curve for concentration measurement.
• Support added for running Zero Verification in secure mode.
• Corrected both Russian and Japanese strings on the local display.
• Enhanced local display to show the hardware revision level.
• Support added for turning the local display either on or off from the local display.
• Support added to the local display so alert conditions can be set to detect (enabled).
• Corrected the byte order swap for DOUBLE_6587_2143.
• Corrected LD compensation diagnostic so it no longer provides a value when LD compensation is turned
off.
Feature additions:
• ProLink III v4.0 contains support for the applicable additional features noted below. If you have ProLink III
v3.0 installed, go to the ProLink Product page by accessing
softwaredownloads. From the Emerson main web page, select Documents & Drawings > Software
Downloads & Drivers to access an update.
• Enhanced SMV functionality.
• Added a screen to the local display to warn the user to put their loop into manual before making
configuration changes.
• Added notification if a user attempts to enter a temporary license that has already been used that explains
why the license is rejected.
• Added Unremediated Mass Flow and Unremediated Volume flow, which can be assigned to the Frequency
Outputs.
• Added Unremediated Mass Flow to the data historian files when APM PG is enabled.
• Created ETO 27577 to disable Gas Density Correction for Large Meters.
In this product, Gas Density Correction is enabled for all sensors Order ETO 27577 if you would like to
disable Gas Density Correction.
• Implemented Modbus function 43 or FDI identification functionality.
• Added new density and flow equation extensions for the CMFS sensors.
• Changed the rebooting option on the local display to reboot both the core processor and the Model 5700
transmitter.
• Added coil 100 so a user can start-resume or pause a batch with a single coil.
Configuration and Use Manual
Software history (NAMUR recommendation NE53)
www.emersonprocess.com/micromotion/
March 2019
275