Connecting The Instrument To A Computer; Connecting With The Gpib; Figure 3-3 Gpib Interconnection - Keysight 53147A Operating And Programming Manual

3 Programming

Connecting the Instrument to a Computer

To program the instrument to operate remotely, you need to interface the
instrument with a computer. The Keysight 53147A, 53148A, and 53149A provide
two interfaces for remote, computer-controlled operation
following sections describe how to connect and configure both interfaces for
remote instrument operation.

Connecting With the GPIB

To connect the instrument to a computer using the GPIB, install an GPIB cable
(such as the Keysight 10833A cable) between the two units, as shown in
Figure
Computer (Rear Panel)
Figure 3-3
Configuring the GPIB
The instrument's GPIB operates in Addressed (talk/listen) mode, which provides
bi-directional communication. The instrument can receive commands and setups
from a computer, and it can send data and measurement results. There is one
configurable setting related to GPIB communication—the GPIB Address.
152
3-3.
GPIB Interconnection
Keysight 53147A/148A/149A Operating and Programming Guide
GPIB and RS-232. The
—
Keysight 10833A/B/C/D
GPIB Cable
Keysight
53147A/148A/149A
(Rear Panel)
Main Power Reference 10 MHz Auxiliary
In or Out
! !
AC POWER FUSE OPTIONS
90-130 VAC 50/60/400 Hz 1.0 A
190-230 VAC 50/60 Hz 001 Oven Time Base
250V
002 Battery
232 GPIB
RS-
To avoid electrical shock: No user serviceable parts inside.
WARNING:
Do not remove covers. Refer all servicing to qualified personnel.
Counter/ Power Meter/ DVM
Made in U.S.A.
This unit must be earth grounded.
of domestic and foreign content