Status Messages - Keysight 53147A Operating And Programming Manual

Status Messages

Table B-1
instrument's front panel.
Table B-1
Message
TESTING
SELF TEST OK
MEASURING
AVERAGING
CH 1 NO SIGNAL
CH 2 NO SIGNAL
CHANNEL 1
CHANNEL 2
NO PM SENSOR
Keysight 53147A/148A/149A Operating and Programming Guide
lists and describes the status messages that are displayed on the
Status Messages
Description
The instrument is performing its Self-Test.
No critical errors were detected during the self-test.
The instrument is sampling the signal and computing a measurement.
The instrument is taking measurements and computing the number of averages
determined by the Averages setting.
The instrument is operational, but no signal can be detected on the selected input.
Identifies the currently selected channel after you press the Chan Select key to
switch channels. CHANNEL 1 or CHANNEL 2 is displayed until the Counter can
display a measurement or determine that no signal is present.
The Power Meter was activated without a power head connected to the input
connector, or the power head is not connected properly or is defective.
Messages B
287