Table of Contents
Advertisement
2
Operating Your Instrument
Table 2-1
Calibration Table Data Points
Factory defined data points
(for 8481A, 8481D, 8482A, 8485A, and 8487A)
Data points added to factory-defined tables by user
Custom calibration-factor tables
(CUST1, CUST2, and CUST3)
Calibration Table Modification Example
This example demonstrates how to view and modify the values in any of the
preconfigured calibration tables or in one of the three custom calibration tables.
1 Press the Shift key, and then press the Menu (Reset/Local) key.
2 Use the up and/or down arrow keys to cycle through the menu until "HEAD
3 Press the right arrow key.
4 Select the model number of the power head you intend to mod ify the data
98
Calibration Factor Data Point Modifications
One of the items in the instrument's menu is displayed (if the menu has not
been used since the instrument was turned on, the initial menu display is "REF
OSC> INT").
> OFF" is shown.
Note that a power head model number (or CUST 1, CUST 2, or CUST 3) may
appear instead of "OFF" if a power-head model was previously selected.
The flashing indicator after HEAD changes from to , and "OFF" (or the
currently selected power head model number) begins to flash.
point(s) for by pressing the up- and/or down-arrow key repeatedly until the
correct model number is d isplayed, and then press Enter.
You can now change the values of the frequency/power-factor data points that
are stored in the instrument's memory (or add data points) by pressing the
right-arrow key while a power-head model number is displayed and pressing
the right-arrow key again when "LIST" is displayed. For instructions on
entering or changing data, see
Keysight 53147A/148A/149A Operating and Programming Guide
Mod ify
All
All
All
"Numeric Entry"
on page 72.
Delete
Reset
Add
None
All
Yes
All
N/A
N/A
All
N/A
Yes
Advertisement
Table of Contents
