Error Messages; Table B-3 Error Messages - Keysight 53147A Operating And Programming Manual

Error Messages

Table B-3
during Self-Test or during operation to indicate that a problem has been
detected. These messages are displayed on the instrument's front-panel display
and are also sent via the RS-232 serial output (note that, in many cases, the exact
message text that is displayed on the front panel is a condensed form of the
message that is sent via the RS-232 interface).
Table B-3
Message
12V FAIL
–12V FAIL
–5V FAIL
ADC FAIL
B1 SIGNAL PATH FAIL
PATH FAIL
B1 THRESHOLD FAIL
THRS FAIL
B2 RF THRESHOLD FAIL
THRS FAIL
B2 THROUGH-PATH
THRESHOLD FAIL
THRS THRU
B2 HETERODYNE PATH
THRESHOLD FAIL
THRS HET
EEPROM FAIL - WRITE
EEP WRT FAIL
Keysight 53147A/148A/149A Operating and Programming Guide
lists and describes messages that are generated by the instrument
Error Messages
Display
X
X
X
X
X
X
X
X
X
X
RS-232 Description
The +12 VDC output from the power supply is not
X
within specifications.
The –12 VDC output from the power supply is not
X
within specifications.
The –5 VDC output from the power supply is not
X
within specifications.
X A failure was detected in the ADC.
X
A failure was detected in the Channel 1 signal path.
X
A failure was detected in the Channel 1 threshold
circuit.
X
A failure was detected in the Channel 2 RF
threshold circuit.
X
A failure was detected in the Channel 2
through-path threshold circuit.
X
A failure was detected in the Channel 2
heterodyne-path threshold circuit.
X
A failure was detected while writing to EEPROM.
Messages B
289