Heated Mirrors - If Equipped; Tilt Side Mirrors In Reverse -If Equipped; Universal Garage Door Opener; Home Link - Jeep GRAND CHEROKEE WK 2022 Owner's Manual

40 GETTING TO KNOW YOUR VEHICLE
To reset the power folding mirrors: Fold and unfold
them by pushing the button (this may require
multiple attempts). This resets them to their
normal driving position.
H M — I E
EATED IRRORS F QUIPPED
These mirrors are heated to melt frost or
ice. This feature will be activated
whenever you turn on the rear window
defroster (if equipped) Ú page 51.
T S M I R
ILT IDE IRRORS N EVERSE
I E
F QUIPPED
This feature provides automatic outside mirror
positioning which will assist with the driver's
ground visibility. The outside mirrors will move
slightly downward from the present position when
the vehicle is shifted into REVERSE. The outside
mirrors will then return to the original position
when the vehicle is shifted out of REVERSE. If the
vehicle is equipped with memory settings, this
feature will be linked to the programmable
settings.
NOTE:
The Tilt Side Mirrors In Reverse feature can be
turned on and off using the Uconnect system
Ú page 152.

UNIVERSAL GARAGE DOOR OPENER

(HOMELINK®)
—
HomeLink® Buttons And Indicator Light
Use this QR code to access your
digital experience.
HomeLink® replaces up to

three hand-held transmitters
that operate devices such as
garage door openers, motor-
ized gates, lighting, or home
security systems. The HomeLink® unit is
powered by your vehicle's 12 Volt battery.
The HomeLink® buttons that are located in the

overhead console or sunvisor designate the
three different HomeLink® channels.
To operate HomeLink®, push and release any

of the programmed HomeLink® buttons. These
buttons will activate the devices they are
programmed to with each press of the corre-
sponding HomeLink® button.
The HomeLink® indicator light is located above

the center button.
NOTE:
HomeLink® is disabled when the Vehicle Security
system is active Ú page 314.
B Y B P
EFORE OU EGIN ROGRAMMING
H L ®
OME INK
For efficient programming and accurate
transmission of the radio-frequency signal, it is
recommended that a new battery be placed in the
hand-held transmitter of the device that is being
programmed to the HomeLink® system. Make
sure your hand-held transmitter is programmed to
activate the device you are trying to program your
HomeLink® button to.
Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the channels
of your HomeLink® before you use it for the first
time.