Further Configuration Options Via Dnc_Ifc.ini - Siemens Sinumerik 840D sl Function Manual

DNC IFC SINUMERIK - Downloading NC Data via a Network (FBDN2)
5 Configuration file

5.3 Further configuration options via DNC_IFC.INI

Configurations on the following parameters must be made directly in the
DNC_IFC.INI configuration file:
Section [GLOBAL]
DataTypeChange =
N = When transferring to a selectable target (Transfer to), it is not permitted
to change the file type.
Y = When transferring to a selectable target (Transfer to), the file type can be
changed by the user. This also applies when conversion tables are configured
in the sections [DNCMMCTypeTab] and [MMCDNCTypeTab]. The
DataTypeChange=Y parameter acts only if DriveInternPath =0.
OverwriteNCData =
0 = Existing NC data files of the same name are not overwritten on the controller.
1 = Existing NC data files of the same name are overwritten on the controller
(default).
!
Warning
The check to determine whether an NC data file already exists on the controller
can only be carried out correctly when the parameter DriveInternPath=0 is
parameterized.
Section [PATHS]
DhsTempPath =
DhsTempPath describes the directory for temporary files. If the parameter is not
set, the temporary directory (temp) is used by Windows.
FBDN2/5-56
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
05.07