Configuration For The Serial Connection Without Protocol - Siemens Sinumerik 840D sl Function Manual

DNC Plant/DNC Cell (FBDN1)
10 Configuration

10.5.2 Configuration for the serial connection without protocol

Configuration dialog for the serial connection without protocol
The machine configuration file is configured in the configuration dialog.
General tab / [GLOBAL] section
The General tab page describes the [GLOBAL] section of the machine
configuration file. The machine server to be used is configured here. You have to
enter the program ID (ProgID) of the machine server to be used. It comprises the
following elements: ComponentName.ClassName.
Note
The serial machine server is called SerIntSvr.Machine (default).
Fig. 10-6: Config dialog / tab: General
Extract from machine configuration file:
[GLOBAL]
MachineServer=SerIntSvr.Machine
FBDN1/10-168
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
05.07