Fast Configuration Via Polystick; Downloading Application And Parameters From Polystick; Customizing Application By Adjusting Parameter Values; Accessing The Parameter Menu - Siemens POLYCOOL RWR470.10 Basic Documentation

Notes
Siemens Building Technologies
HVAC Products
5

Fast Configuration via PolyStick

Only trained staff can perform fast configuration via PolyStick.
Downloading Application and Parameters from
PolyStick
To download application and parameters from PolyStick to the controller, follow steps
below:
• Power off the controller
• Plug PolyStick into RJ45 service interface
• Re-apply power to the controller
• Wait while the green LED is continuously blinking, indicating the data communication
process
• Once finished, the controller will be set in Stop mode, and the green LED fixed
• Un-plug the PolyStick
• Press <Esc> to activate the system from Stop mode
6 Customizing Application by Adjusting
Parameter Values

Accessing the Parameter Menu

Display
In Stop mode, press <Enter> for 2 seconds and release it to activate the Menu mode.
When the icon is blinking, press <Plus> or <Minus> to navigate to the
and then press <Enter> to proceed.
Contents under the
• For end users, select "NO" and press <Enter > to proceed.
• For service men and factory users, select "EU" or "ID"and press <Enter>. Input the
4-digit password when the following screen is displayed
.
SIEMENS Controller
Procedures
menu may vary with the privilege right of the user.
Press <Enter> to confirm and continue to
input the password.
+
-
menu,
12/28
HEAT PUMP controller
27.11.2006