05.07
Machine Server tab page / [SERINTSVR] section
Fig. 10-7: Config dialog / tab: Machine Server
The Machine Server tab is the [SERINTSVR] section of the machine configuration
file. Here, you configure the code conversion server to be used. You have to enter
the program ID (ProgID) of the code conversion server to be used. It comprises the
following elements: ComponentName.ClassName.
Note
The code conversion server is called: DNCConv.CodeConvert (default)
If the code conversion server is to be called by a different machine server, you
are advised to assign a new section.
!
Warning
Do not enter a code conversion server if code conversions are not to be carried
out.
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
DNC Plant/DNC Cell (FBDN1)
10 Configuration
FBDN1/10-169