Siemens Sinumerik 840D sl Function Manual page 290

DNC IFC SINUMERIK - Downloading NC Data via a Network (FBDN2)
2 System requirements
2.1 Hardware
DNC IFC SINUMERIK can run on SINUMERIK* with the following hardware:

PCU 50/70 with OP 010/012/015, TCU, HT8

MMC103 with OP 031/032
and additionally:
- PCI/ISA adapter
- Ethernet network interface
2.2 Software
The following SINUMERIK software is required for DNC IFC SINUMERIK:

HMI software as of SW Version 6
under Windows NT/XP on PCU 50/70

MMC software as of SW Version 4.04.17
(only possible on request for a specific project)
under Windows 95 on MMC 103
Note
There are function restrictions when using MMC 103 (e.g. no archiving, no quick
filter).
SINUMERIK*:
FBDN2/2-8
SINUMERIK 810D
SINUMERIK 840D
SINUMERIK 840Di
PCU50 under Windows with SINUMERIK 840D sl
Motion Control Information System DNC (FBDN) - 04/10 Edition
© Siemens AG 2010 All Rights Reserved
05.07
