Diagnostics Via Configuration Software Of The Controller - Siemens PROFINET SIRIUS 3RW5 Equipment Manual

State
Flashes green / red
"BUS" LED
State
LED "LINK", "LINK 1" and "LINK 2"
State
For the 3RW5 PROFINET High Feature communication module, the assignment LINK 1 - Port 1 and
1)
LINK 2 - Port 2 applies.
7.2

Diagnostics via configuration software of the controller

When a certain fault occurs, the 3RW5 soft starter generates an interrupt as an IO device and
sends it to the IO controller. The CPU of the controller then interrupts processing of the user
program and calls up interrupt OBs automatically. The OB number and start information already
provide you with information on the cause and type of fault.
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004
Meaning
The "node flash test" was activated.
No supply voltage (control supply voltage) available.
Off
Meaning
Device performing data exchange.
Lights up green
Bus error
Lights up red
Configuring error
Flashes red
• Device not performing data exchange (e.g. controller is in stop state).
• No supply voltage (control supply voltage) available.
Off
Meaning
There is a PROFINET connection between the 3RW5 communication module
and a communication partner (e.g. IO controller).
Lights up green
The "node flash test" was activated.
Flashes green
• There is no PROFINET connection between the 3RW5 communication
module
Off
• No supply voltage (control supply voltage) available.
7.2 Diagnostics via configuration software of the controller
and a communication partner (e.g. IO controller).
1)
Messages and diagnostics
1)
71