Table 10-6: Comment During Transmission - Siemens Sinumerik 840D sl Function Manual

DNC Plant/DNC Cell (FBDN1)
10 Configuration

Start-of-program identifier
The start-of-program identifier specifies the marker for the start of the program
as an ASCII character in decimal code (0 ...255), which is inserted before each
NC data file (example: 065 for A).
Extract from machine configuration file:
ProgramStart=65

End-of-program identifier
The end-of-program identifier specifies the marker for the end of the program
as an ASCII character in decimal code (0 ...255), which is inserted after each
NC data file (example: 069 for E).
Extract from machine configuration file:
ProgramEnd=69

Comment start
The comment start identifier specifies the marker for the start of the comment
as an ASCII character in decimal code (0 ...255), which is inserted before each
comment (example: 075 for K).
Extract from machine configuration file:
CommentStart=75

Comment end
The comment end identifier specifies the marker for the end of the comment as
an ASCII character in decimal code (0 ...255), which is inserted after each
comment (example: 101 for e).
Extract from machine configuration file:
ProgramEnd=101

Suppress comment
This checkbox enables a comment to be suppressed so that it is not
transmitted.

Table 10-6: Comment during transmission

0 Comment is transmitted
1 Comment is suppressed
Extract from machine configuration file:
SuppressComment=1
FBDN1/10-176
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
05.07