Table 6-5: Configuration Parameters For The Dialog Function; Configuration Parameters - Siemens Sinumerik 840D sl Function Manual

DNC Plant/DNC Cell (FBDN1)
6 Dialog function

6.4 Configuration parameters

The configuration parameters for the dialog function are defined in the machine
configuration files (.MCF) in the [DIALOGFUNCTION] section. The standard
configuration parameters and their meaning are listed in the table below.
Note
This section of the machine configuration file can also be created in the
configuration dialog, which is described in Section Configuration  Configuration
dialog  Dialog function tab page.

Table 6-5: Configuration parameters for the dialog function

Configuration parameters
DlgScanLines
DlgID
DlgIDSend
DlgSendEnd
DlgSendCmd
DlgSendTcCmd
DlgReceiveCmd
DlgSendListCmd
DlgWpdMark
FBDN1/6-136
Description
Number of rows to be searched through for a
DlgID parameter in the NC data file, starting from
row 1.
ID for a dialog program for a formulated request
ID for a response to a formulated request. The
response can have the following content:

List (response to list request)

Error message (response to a program
request that cannot be fulfilled)
Program end of a response (list, error) from DNC
.
to the machine
Command to download released NC data files.
Command to download NC data with trial cut ID
Command to upload NC data files. Two programs
are sent one after the other:

Request program

Program to be uploaded
Command to request a list. The ID must be in the
1st line of the NC data file.
ID for workpieces in the dialog program. In the
case of controllers that cannot edit all characters,
path information or conditions (e.g. Z888 or
G040) are also possible.
Motion Control Information System DNC (FBDN) - 04/10 Edition
Standard
configuration
10
%MPF9999
%MPF9998
M30
(S)
(ST)
(R)
(SL)
WPD
© Siemens AG 2010 All Rights Reserved
05.07