Configuration In The Machine Configuration File - Siemens Sinumerik 840D sl Function Manual

DNC Plant/DNC Cell (FBDN1)
12 Auto archiving

12.2.3 Configuration in the machine configuration file

General
Machines should be configured in DNC Admin. To do so, enter configuration
mode in DNC Admin, choose the required machine, and open the Machine
Properties dialog. To fetch the required machine configuration file, choose
Edit. If this machine does not yet have a configuration file, you can create and
open one containing the standard parameters for the SINUMERIK transmission
module.
The [COMPARE] section is reserved for the auto archive. Here, you can specify
the DM directories that are to be compared with the DNC system during the archive
run. For each DM directory, you can also decide whether files in the directory are to
be archived in a pseudo workpiece with the workpiece name *.DIR and which file
types are included in the archive run. You can also exclude individual files in each
DM directory from the comparison and archive run.
The parameters in a DM directory are separated by means of ";".
Note
The auto archive function is station dependent, which means that only machines
in one particular station are compared and archived.
DHDIR...
Here, you can define up to 30 DM directories for each machine (DHDIR1 ...
DHDIR30).
The numbering dictates the sequence in which the DM directories are compared
and archived.
The numbering can contain gaps.
Extract from machine configuration file:
DHDIR1 = MPF.DIR;0; MPF
DHDIR3 = SPF.DIR;0; SPF
FBDN1/12-268
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
05.07