Table of Contents
Advertisement
Switches and buttons
With the low beam headlights on, pull the switch (C) to turn on the high beam lights.
To switch the high beam lights off again, pull or push the switch (C).
With the low beam lights off, push the switch (C) to flash the high beam lights.
The high beam lights may be flashed with the low beam light off only with the ignition switch in position II.
If the high beam light switch is turned on, the high beams will come on each time the headlights switch on
automatically. Preferably turn the high beam switch off once the twilight sensor switches off the lights.
With the ignition key turned to 0 or removed, push the switch (C) within 3 minutes from switching off the engine
(or within 30 seconds if the driver side door is opened) to activate the "Follow me home" function, which
illuminates the area surrounding the vehicle to allow the occupants to walk safely in dark conditions. Each
time the switch (C) is pushed again increases the time that the low beam lights remain on in increments of 30
seconds, up to a maximum of 210 seconds.
Windscreen wiper, windscreen washer and headlight washer control
Push and pull the switch (D) to activate and deactivate the windscreen wiper and washer.
The windscreen wiper and washer will only work with the ignition switch in position II.
The windscreen wipers have four speed settings:
OFF: windscreen wiper off;
AUTO: the rain sensor regulates the windscreen wiper frequency in relation to rain intensity;
Page 2 of 18
Advertisement
Table of Contents
