Sensor Activation Logic; Time Between Attempts For Activating The Sensor - Siemens HiPath 1100 Programming Manual

Relay and Sensor on the HiPath 1120
Step by Step
0 0
166

Sensor Activation Logic

The sensor's main position can be set as follows:
• Contacts are closed. The sensor is activated when
contacts are open
• Contacts are open. The sensor is activated when
contacts are closed
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 7 4
or
0 1 Select the main position for the sensor:
0 = Contacts closed (default)
1 = Contacts open
Press this key.
#
Initial state for Programming Mode.
Time between Attempts for Activating the
Sensor
This setting specifies a timeout after which a new at-
tempt is made to call an internal or external number, as-
suming that the line was busy on the previous attempt.
The default setting is 3 minutes.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 0
... 1 0 Select a timeout until the next attempt (0 to 10 min-
utes).
Initial state for Programming Mode.