Disconnect Timeout After And External-To-External Transfer (Code 183); Code For A Disconnect Timeout After And External-To-External Transfer - Siemens HiPath 1100 Programming Manual

Step by Step
0 0 4
Disconnect timeout after and external-
to-external
transfer (Code 183)
With this option you can specify a period of time for
disconnecting an external call. This option applies when
at least one external line is an analog line and the call is
transferred (Code 091) or forwarded (*11) to an external
destination by an authorized extension.
Required: Programming Mode must be active (*95
31994).
1 Enter the code for programming.
8 3
...
Enter the length of time for disconnecting calls (004 to
1 2 0
120 in 5-second cycles) where 004 = 20 seconds...
060 = 300 seconds (default), etc.
Initial state for Programming Mode.
Code for a disconnect timeout after
and external-to-external
transfer.
This option allows you to set a code to restart the
timeout period for disconnecting an external call. This
applies when at least one external line is an analog line,
and after a call has been transferred (Code 091) or
forwarded (*11) to an external destination by an autho-
rized extension.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 8 4
Enter a code for restarting the timeout, between 00 and
99 (default is 00).
Initial state for Programming Mode.
Programming an Extension
89