Digit Suppression In Call Detail Reports; Call Detail Report For Incoming Calls - Siemens HiPath 1100 Programming Manual

Call Detail Report Manager
Step by Step
126
Digit Suppression in Call Detail Re-
ports
The last digits dialed in an external call can be sup-
pressed in the data output. These digits are replaced by
"?."
By default, no digit is suppressed.
Required: Programming Mode must be active (*95
31994).
1 2 1 Enter the code for programming.
...
Select the number of digits to be suppressed.
0 9
Initial state for Programming Mode.

Call Detail Report for Incoming Calls

If the system is enabled for analog and digital line Caller
ID (E1 CAS or S2 access) provided by a local carrier, the
call information will be displayed on the Call Detail Re-
port.
The columns "Ext" (Extensions), "Ring" (Ring Duration),
"Duration" (Call Duration) and "Call fees" (Pulses) remain
empty while the column "I" (Type of Call) shows an " * "
next to the call.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6 1
1 ... 4 Enter the code for the type of Call Detail Report.
1 = Outgoing calls are recorded at the end of the call.
= Outgoing calls are recorded at the end of the call.
2
= Outgoing calls are recorded at the end of the call.
3
Incoming calls (with or without Caller ID at the
source) are recorded at the end of the call
(default).
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
Incoming calls (with or without Caller ID at the
source) are recorded at the end of the call.