Dialing Mode; Flash Detection Time - Siemens HiPath 1100 Programming Manual

Programming an Extension
Step by Step
0 0 1
74

Dialing Mode

The Dialing Mode designates the dialing method as
pulse (DP), tone (DTMF) or automatic detection.
Required: Programming Mode must be active (*95
31994).
1 6 8 Enter the code for programming.
Enter the extension number (e.g., 12/102).
...
0 2 Enter the code for the dialing mode:
0 = Automatic detection of Dialing Mode (default)
1 = Pulse
2 = Tone
Enter the next extension number
or
Press this key.
#
Initial state for Programming Mode.

Flash Detection Time

The Flash Detection Time is the maximum period of
time required by a PABX to detect a flash signal gener-
ated by an internal telephone. If older MF dialing tele-
phones are connected to the system, it may be neces-
sary to adjust the Flash Detection Time to their
response times (see manufacturer's instructions). The
specified Flash Detection Time may vary for different
countries.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 3 1
Enter the extension number (e.g. 12/102).
...
Enter Flash Detection Time (001 to 250, in increments
2 5 0
of 10 ms), where 001 = 10 ms... 010 = 100 ms ... 035 =
350 ms, etc
For Portugal, Argentina and Thailand the default setting
is "035"; for other countries "028".