Hipath 1120 Alarms; Emergency Numbers - Siemens HiPath 1100 Programming Manual

General Programming
Step by Step

HiPath 1120 Alarms

You can assign an alarm to a system sensor. When the
alarm is triggered, the system dials the number stored
as entry 249 in the Speed Dialing phonebook (the name
assigned to this entry can be up to 15 characters long.
For example, it can be the name of an emergency sta-
tion).
The system ID is automatically sent and continues to be
sent to the station called until the service requested re-
turns the "#" digit, acknowledging the alarm "#". This
works as a confirmation that the service has detected
the alarm call sent by the system.
If a Fax/DID module is installed, you can send an alarm
message in addition to the Exchange ID.
When an alarm is triggered, the HiPath 1120 makes a
call using the Speed Dialing entry 249. The slot number
is called and a previously programmed sequence of dig-
its (in DTMF format) is repeated every 6 seconds after
the connection is established.
The purpose of this sequence of digits is to identify the
alarm source. An alarm center, for example, is able to
identify which PABX is sending the signal. If the receiv-
ing switch does not acknowledge the alarm within a
few minutes, the procedure is repeated at specified
time intervals.
For information on how to program this feature refer to
the topic describing the programming of the Sensor and
Relay for the HiPath 1120""Audio Quality"."

Emergency Numbers

You can specify up to five emergency numbers. When
one of these numbers is dialed and all external lines are
busy, the call on the first external line will be interrupted
and the line used for making the emergency call. A call
is not disconnected only if it is an incoming call over an
external analog line.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 4 0
... Select the slot for the emergency number
1 5
(1 to 5.)
109