Electronic Lock Password; Timeout For Call Forwarding - No Answer - Siemens HiPath 1100 Programming Manual

Programming an Extension
Step by Step
0 1
70

Electronic Lock Password

This option allows you to set a 5-digit password to pro-
tect an extension against unauthorized use. When this
option is selected, only internal calls or Speed Dial calls
can be made from the extension. If it occurs that an ex-
tension's user forgets the password used to block the
extension, the password can be reset to the system's
default (default password is 0000).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 2 6
Enter the extension number (e.g., 12/102).
Enter a 5-digit password to set an electronic lock for the
extension (default is 00000)
or
Delete the electronic lock password (it defaults to
*
00000)
or
Initial state for Programming Mode.
Timeout for Call Forwarding - No An-
swer
This feature specifies a timeout for the First Attendant to
answer an incoming call. If the call is not answered, it is
forwarded to a Second Attendant, as programmed (see
Call Forwarding - No Answer in the Manual do Usuário).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 3 0
...
Enter the length of time (01 to 99 in 5-second incre-
9 9
ments) where 01 = 5 seconds... 06 = 30 seconds (de-
fault).
Initial state for Programming Mode.
A blocked extension can only make internal calls
using the System Speed Dialing phonebook (ab-
breviated numbers) if its Class of Service is not
changed (see "Special Class of Service for a
Blocked Extension").